|Place of Origin:||Guilin, China|
|Minimum Order Quantity:||5pcs|
|Delivery Time:||5-8 work days|
|Payment Terms:||L/C, D/A, D/P, T/T, , MoneyGram, RMB|
|Battery Mode:||ICR 18650- 2600mAh||Battery Votage And Capacit:||3.6V/2600mAh|
|Light Intensity:||1000mW/cm2 - 2500mW/cm2||Dimensions:||26mmx255mm|
5W Dental Curing Light,
1 Second Dental Curing Light,
5W woodpecker light cure
5W High Power Colorful Blie LED 1 Second Dental Curing Light for Clinic
1 Modes setting: Lightly press the mode key to change the running modes. The Curing Light will shine the diffrent lluminated blue light.The available modes see the Technical Parameters table.
2 Time setting: Lightly press the time button to choose the solidification time. The available time setting see the Technical Parameters table.
3 During the operation, aim blue light at the position needing solidification. Press the power button "ON/OFF" switch, a "beep" sound will appear, the Curing Light starts to work under the selected mode. Then it counts down to "0" second to end the solidification.
4 During operation, the blue light can be stopped by press the power button "ON/OFF" at any time.
5 Low power detect circuit is fixed inside of the main unit, when low power is detected, the indicator of the main unit will wink, please charge in time.
6 After the operation, please clean the fiber with calico in order not to affect the light intensity.
7 This equipment will tum off automatically if no any action within 2 minutes, tum it on by press "ON/OFF" button.
8 The depth of solidification of composite is no less than 4mm per 10 seconds.
|Name||5W High Power Colorful Blie LED Dental Curing Light|
|Feature||1 Second Curing|
|Power Supply||100-240V, 50hz/60hz|
Cleaning, disinfecting and sterilizing
1 Please conform to the recommendations of the manual "Reprocessing Instructions of Cleaning, Disinfecting And Sterilizing" delivered with your product regarding the procedure of cleaning, disinfecting, sterilizing and packing of the components. Follow present-day regulations enforced in the country about reprocessing. The use of scouring powder or an abrasive sponge will damage its surface.
1 Excessive impact and shake should be prevented in the transportation. Lay it carefully and lightly and
don't invert it.
2 Don't put it together with dangerous goods during transportation.
3 Avoid solarization and getting wet in rain or snow during transportation.
1 Don't store the machine together with the articles that is combustible, poisonous, caustic, or explosive.
2 This equipment should be stored in a room where the relative humidity is 10%-93%, atmospheric pressure is 70kPa-106kPa, and the temperature is -20°C-+40°C.
1 The equipment should be handled carefully and lightly. Be sure that it is far from the vibration, and installed or kept in a cool, dry and ventilated place.
2 Please turn off the electrical source if not use it, if not use for a long time, please make the machine get through to the power once 3 months for five minutes.
The products have been designed for a large number of sterilization cycles. The materials used in their manufacture were selected accordingly. However with every renewed preparation for use, thermal and chemical stresses will result in aging of the products. If the number of permissible re-sterilization cycles is restricted, this will be pointed out in the product specific instructions. The use of ultrasound baths and strong cleaning and
disinfection fluids (alkaling pH>9 or acid pH<5) can reduce the life span of products. The manufacturer accepts no liability in such cases.
The products may not be exposed to temperatures above 138°C.
Contact Person: Chloe Yao